CREATE HOTSPOT USING COMMAND PROMPT(CMD)
STEP 1. START HOTSPOT
STEP 2. RUN CMD (RUN AS ADMINISTRACTOR)
then you see this type of box
THEN TYPE THE
TYPE
netsh wlan set hostednetwork mode=allow ssid=ravi key=123456789
PRESS KEY ENTER
THEN THIS TYPE OF BOX YOU CAN SEE
TYPE
netsh wlan start hostednetwork
PRESS ENTER
THEN OPEN YOUR MOBILE AND CONNECT WITH PC
YOUR PASSWORD KEY IS HERE=123456789
BECAUSE I SET IN MY HOSTEDNETWORK KEY=123456789
EX. YOU CAN GIVE ANOTHER KEY=RAVI1382016
YOU CAN SET AS YOU LIKE
BUT KEY MUST BE NEED TO 9 CHARACTER
AFTER YOU CONNECT THE PC WIFI
BUT YOUR MESSAGE IS NOT LOADED
THEN YOU NEED TO GO TO
ETHERNET SETTING -----> RIGHT CLICK WHICH IS DRAW BY RED
THERE ARE TWO OPTION
SELECT THIS ------------------->>> OPEN NETWORK AND SHARING CENTER
THEN SEE THIS TYPE OF BOX IN YOUR SCREEN
GO TO------>CHANGE ADAPTER SETTING
THEN YOU CAN SEE THIS TYPE OF BOX
RIGHT CLICK ON ETHERNET GO TO------> PROPERTIES
PRESS ENTER
THEN YOU CAN SEE THIS TYPE OF BOX
THEN CLICK ON SHARING
YOU CAN SEE BOX AS DISPLAY BELOW
ENABLE THE CHECK BOX IF IT DISABLE
THEN
SEE
HOME NETWORKING CONNECTION
AND SELECT THE OPTION:- Local Area Connection* 4
YOU CAN SEE BELOW :-
AND CLICK OK
END
STOP THE HOSTSPOT
netsh wlan stop hostednetwork
and again start
netsh wlan start hostednetwork
---------------------------------------------------------------------------------------------------------------------------
CMD CODE:-
netsh wlan set hostednetwork mode=allow ssid=ravi key=123456789
netsh wlan start hostednetwork
netsh wlan stop hostednetwork
NOTE:- do not close still you need to wifi for mobile (minimize this)
Comments